OmniVision OV8835 8-megapixel image sensor

If you figure out that your 8-megapixel camera on your smartphone could perform even better, you are correct – too bad that assumption will only come true in the future should phone manufacturers fall upon the OmniVision OV8835 8-megapixel image sensor to be included in their upcoming offerings. Constructed on improved OmniBSI-2 pixel architecture, the OmniVision OV8835 8-megapixel image sensor will allow one to capture full resolution 8-megapixel photography at 30 FPS and shoot 1080p/30 HD video with electronic image stabilization.

Since it delivers pin-to-pin compatibility with the previous generation OV8830 image sensor, it should be a simple matter of incorporating these new image sensors into the same circuit board that carry the OV8830 image sensor. It is said that the latest offering delivers a 20% improvement in low-light performance and a 25% improvement in full-well capacity. We can’t wait to see the performance of this new image sensor in upcoming smartphones. Volume production of the OmniVision OV8835 8-megapixel image sensor is expected to begin sometime before the year is over, so the earliest you will see it in action would be in 2013.

By Ubergizmo. Related articles: OmniVision unveils 12.7 megapixel OV12830 for high-end smartphones and tablets, OmniVision unveils 16MP image sensors with 4k video capture capabilities,

OmniVision announces low-cost 5MP CMOS image sensor with high-end features

A camera is arguably one of the most indispensable features on a smartphone, being a necessary component in certain apps, such as barcode scanners, in addition to providing a simple way to take pictures/video and share them without hassle. The cameras in higher-end smartphones offer a variety of features you won’t easily find in less expensive models, and often provide poor images in low light settings. OmniVision aims to change this, however, with its newly announced 5MP OV5645 CMOS sensor.

The OV5645 is a 5MP system on chip (SOC) sensor aimed at the “cost-sensitive” segment of the smartphone market. The sensor features a MIPI port, which replaces a JPEG compressor and DVP interface, making it both smaller and cheaper than other options. This little CMOS sensor features picture-in-picture architecture that provides a dual camera system based on a master/slave configuration, allowing smartphones to offer two cameras via a single MIPI interface.

The OV5645 offers video recording in 720p at 60 frames-per-second, and 1080p recording at 30 frames-per-second. According to the announcement, 720p recordings have improved sensitivity and signal-to-noise ratio. A filter function is in place to minimize spatial and zigzag artifacts.

OmniVision’s new sensor also features OmniBSI+ technology, which is aimed at providing high quality via low noise levels, low crosstalk, and high sensitivity. The OV5645 supports black sun cancellation, LED and flash strobe modes, anti-shake, and more. Overall, this sensor brings a cost-effective way for smartphones to offer improved video and photos via a higher-sensitivity and better low-light performance without unnecessary hardware and cost.

[via OmniVision]


OmniVision announces low-cost 5MP CMOS image sensor with high-end features is written by Brittany Hillen & originally posted on SlashGear.
© 2005 – 2012, SlashGear. All right reserved.


OmniVision unveils 5MP BSI sensor that takes low light cameras further into the entry level

OmniVision unveils 5MP sensor that takes low light photography to the entry level It’s almost a truism that starter smartphones have poor cameras that struggle just to get pristine photos in broad daylight, let alone dim interiors. Thankfully, OmniVision’s new OV5645 sensor could lead newcomers out of a very literal darkness. The 5-megapixel imager includes backside illumination, support for 1080p30 (or 720p60) video and its own internal autofocus system, but no dedicated JPEG compression engine — in short, a lot of the low-light performance of more sophisticated smartphones without the usual attached costs. Its cost-cutting even extends to front cameras, as a forward-facing sensor can share resources with the back camera to scale back on redundant hardware. We’re looking forward to when mass production starts in the first quarter of 2013; we might not have to excuse our photo quality for a long, long time afterwards.

Continue reading OmniVision unveils 5MP BSI sensor that takes low light cameras further into the entry level

Filed under: , ,

OmniVision unveils 5MP BSI sensor that takes low light cameras further into the entry level originally appeared on Engadget on Mon, 29 Oct 2012 17:39:00 EDT. Please see our terms for use of feeds.

Permalink   |  sourceOmniVision  | Email this | Comments